NM360 Abrasion Resistance Steel Plates
NM360 Abrasion Resistance Steel Plates
NM360 Abrasion Resistance Steel Plates
NM360 Abrasion Resistance Steel Plates
NM360 Abrasion Resistance Steel Plates

NM360 Abrasion Resistance Steel Plates

Chemical composition of NM360 wear-resistant steel plate:
Carbon C content: 0.25;
Si content: 0.70;
Mn content: 1.60;
P content: 0.025;
Sulfur S content: 0.015;
Chromium Cr content: 0.80;
Nickel Ni content: 0.50;
Molybdenum Mo content: 0.50;
Ti content: 0.050;
Aluminum Als content: ≥0.010;

Send Inquiry

Product Introduction

NM360 Abrasion resistance steel plates

mechanical property

mark	hardness	tensile property	20℃AKV crosswise J
RP0.2	A50%
MPa
WNM360	320～400	≥800	≥1000	≥10

NM360 steel plate surface quality

A, the surface of the steel plate is not allowed to have cracks, bubbles, scars, folding and inclusion and other defects. The steel plate must not be layered. If there are the above surface defects, it is allowed to clean up, and the cleaning depth shall not exceed half of the thickness tolerance of the steel plate from the actual size of the steel plate, and the minimum thickness of the steel plate shall be guaranteed. The defect cleaning place should be smooth and without edges.

B, the surface of the steel plate is allowed to have a thin layer of iron oxide, rust, surface roughness, scratches, indentation and other local defects caused by the pressed iron sheet falling off, but the depth shall not be greater than half of the thickness tolerance, and the minimum thickness of the steel plate shall be guaranteed.

NM360 wear-resistant steel plate application range:

It is mainly to provide protection in the need of wear-resistant occasions or parts, so that the equipment life is longer, reduce the maintenance and shutdown caused by maintenance, and correspondingly reduce the investment of funds.

Engineering machinery, mining machinery, coal mining machinery, environmental protection machinery, metallurgical machinery, crusher, crusher, dump truck, container, screen plate, feeder, feeding funnel, hoist, blade plate, knife plate, gear, sprocket, lining plate, bolted blade plate, wear-resistant strip chute, cutting tool, hammer, etc., are also commonly used as yield strength ≥700MPa high-strength structural steel.